Urethral Catheterisation (Male)
Foreword
This skill involves you inserting a catheter into a male patient's bladder. It is performed for many reasons e.g. occasionally patients with urinary problems need them long term, acute urinary retention or if the patient is acutely unwell to help closely measure their input and output.
This station always involves a model, but you must remember to act as though you are talking to a patient. Catheterisation can be tested on a male or female model, but here we will discuss male catheterisation (see Female Urethral Catheterisation).
There are two main ways to perform catheterisation:
- The 2-Glove Technique.
- The Clean Hand / Dirty Hand Technique.
You should use the one your medical school teaches; in this demonstration we use the clean hand/dirty hand technique.
Procedure Steps
Step 01
A chaperone is required for this procedure.
Begin by introducing yourself to the patient and clarify his identity. Explaining what you are going to do and obtain his consent.
Step 02
Prepare your equipment for this procedure. This is:
- A catheterisation pack.
- A 12 – 14 Fr male Foley catheter.
- A catheter bag.
- Antiseptic solution.
- Sterile gloves.
- Lignocaine gel.
- A 10ml sterile water -filled syringe.

Step 03
Position the patient on his back with legs slightly apart, and lying as flat as possible.
Step 04
Using an aseptic technique open the catheter pack and pour antiseptic solution into the receiver. Open the rest of your equipment onto the sterile field.

Step 05
Wash and dry your hands, then put on the sterile gloves.

Step 06
Drape the patient and place a collecting vessel between the patients legs.

Step 07
Hold the penis with a sterile swab and clean the penis thoroughly. Remember to retract the foreskin and clean around the urethral meatus.

Step 08
Insert the lignocaine gel and hold the meatus closed with pressure from the swab. Indicate that the anaesthetic needs 5 minutes to work.

Step 09
Hold the penis vertically with one hand and with the other hold the catheter by its sleeve. Advance the catheter tip from its sleeve and insert into the urethra.

Step 10
Progressively insert the catheter, ensuring that neither your hand nor the sleeve touch the penis until the end arm reaches the meatus. At this point urine should start to flow into the collecting vessel.

Step 11
Inflate the balloon using 10ml of sterile water, ensuring that it does not cause any pain. NB the volume used to fill the balloon may vary depending upon the size of the catheter used, check the packaging for the exact volume to use.

Step 12
Attach the catheter bag.
Step 13
Gently pull on the catheter until resistance is felt. This is when the balloon will be resting on the urethral opening of the bladder. Then reposition the foreskin.

Step 14
Dispose of your gloves and equipment in the clinical waste bin. Wash your hands.
Step 15
Record the volume of urine collected in the catheter bag and ensure that the patient is comfortable and covered. Remember to complete the sticker on the outside of the catheter pack and put it into the patients notes.